Using a Laser Level
There are many jobs in construction that greatly facilitate the use of this device. These include:
Application of a laser level
- delimitation of territory, marking, setting directions;
- determination of horizontal and vertical lines when installing equipment;
- leveling the floor when pouring cement, laying tiles;
- installation of walls, partitions;
- installation of electrical cables;
- construction of stairs.
It allows you to construct horizontal and vertical planes with high measurement accuracy. If a professional level is used, its error is only 0.02 mm.
It is easy to use, and the work done with it is neat and of high quality. When turned on, the worker sees not the end point on the opposite wall, but the entire light line, which is easy to navigate and perform work strictly in the position required. If necessary, simple repairs to the laser level can be done right during operation.
The area can be of any size - the laser beam has no restrictions on its length and will continue until it encounters an obstacle in its path. In addition to high precision, this is another advantage over conventional tools.
Its operation is not affected by strong winds, high temperatures or other external factors. It is equipped with electronic sensors that instantly determine the horizontal and vertical lines.
Tags: laser level, adjustment, setup.
Comments 31
I need to try it, the same level is lying around (it was dropped during the repair process and began to give an error of 3 cm by 2 meters
That's how I took apart my capro!
I have a broken capro, is there a way to fix it?
It depends! I repaired mine after a fall. But one of them never got fixed. There's a control board there. What capro do you have?
Thanks for the idea!
Thank you, I just bought this one myself about 6 years ago. Now I started lying, I knew that it could be adjusted, but I was too lazy to figure it out.
Dad also adjusted it, but only the horizon, not the vertical.
I had one of these fall off my stool - it became a rattle, took it apart, glued a couple of holders together with super glue, thought about adjusting it - measured it - perfect)))
Isn't this a line generator (or a plane builder) by any chance?
this is a laser level or level
I'll be boring of course
